Electra OU7-24 RC Manual de servicio Pagina 153
- Pagina / 168
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5
Necessary room
outlet inlet outlet
Chart 1
ground
Drain side Tubing side
780 (Hook-location)
840 (Body)
880 (Ceiling hole)
950 (Panel)
Chart 2
(Unit: mm)
Chart 3
780 (Hook-location)
840 (Body)
880 (Ceiling hole)
950 (Panel)
Note: 24/27/30 Series A 260mm
36/45 Series A 330mm
INDOOR UNIT INSTALLATION
1. Install the main body
A. The existing ceiling (to be horizontal)
a. Please cut a quadrangular hole of 880X880mm in the ceiling according to the shape of the installation
paper board. (Refer to Chart 3, 4)
• The center to the hole should be at the same position of that of the air conditioner body.
• Determine the lengths and outlets of the connecting pipe, drainpipe and cables.
• To balance the ceiling and to avoid vibration, please enforce the ceiling when necessary.
b. Please select the position of installation hooks according to the hook holes in the installation board.
• Drill four holes of M12mm, 45-50mm deep at the selected positions on the ceiling. Then embed the
expansible hooks (fittings).
• Face the concave side of the installation hooks towards the expansible hooks. Determine the length
of the installation hooks from the height of ceiling, then cut off the unnecessary part.
The length could be calculated from Chart 5:
Length= H-181+L ( in general, L=100mm and is half of the whole length of the installation hook)
c. Please adjust the hexangular nuts on the four installation hooks evenly, to ensure the balance of the
body.
• If the drainpipe is away, leakage will be caused by the malfunction of the water-level switch.
• Adjust the position to ensure the gaps between the body and the four sides of ceiling are even. The
body’s lower part should sink into the ceiling for 10-12mm (Refer to Chart 5).
• Location the air conditioner firmly by wrenching the nuts after having adjusted the body’s position
well.
SZ000289/En 06/23/2004, 2:39 PM17
CONTENT
- KN Cassette R410A Series 1
- LIST OF EFFECTIVE PAGES 2
- Table of Contents 3
- 1. INTRODUCTION 4
- 1.6 Outdoor Unit 5
- 1.7 Tubing Connections 5
- 1.8 Accessories 5
- 1.9 Inbox Documentation 5
- 1.10 Matching Table 6
- 2. PRODUCT DATA SHEET 7
- 2.2 KN 24 / OU7-24T R410A 8
- 2.3 KN 30 / OU8-30 R410A 9
- 2.4 KN 30 / OU8-30T R410A 10
- 2.5 KN 36 / OU10-36 R410A 11
- OUTDOOR 11
- PRODUCT DATA SHEET 12
- 3. RATING CONDITIONS 14
- 4. OUTLINE DIMENSIONS 15
- 4.2 Outdoor Unit: OU7-24 16
- 4.3 Outdoor Unit: OU8-30 16
- OUTLINE DIMENSIONS 17
- 5. PERFORMANCE DATA 18
- 5.2.1 Heating 19
- 5.3.1 Cooling 20
- 5.3.2 Heating 21
- 5.4 KN30 / OU8-30 R410A 22
- 5.5.1 Heating 23
- 5.6 KN30 / OU8-30T R410A 24
- 5.7.1 Heating 25
- 5.8 Pressure Curves 26
- 5.8.2 Heating 27
- 5.9 Pressure Curves 28
- -10 -5 0 5 10 15 20 29
- 5.9 KN36 / OU10-36 R410A 30
- 5.10.1 Heating 31
- 5.11 Pressure Curves 32
- 5.12 KN36 / OU10-36T R410A 34
- 5.13.1 Heating 35
- 5.14 Pressure Curves 36
- 5.14.2 Heating: 37
- 5.15 KN45 / OU10-47T R410A 38
- 5.16.1 Heating 39
- 5.17 Pressure Curves 40
- 5.17.2 Heating 41
- 6. ELECTRICAL DATA 42
- ELECTRICAL DATA 43
- 7. WIRING DIAGRAMS 44
- WIRING DIAGRAMS 45
- 7.6 Outdoor Unit: OU10-36 46
- 7.7 Outdoor Unit: OU10-36T 47
- 7.8 Outdoor Unit: OU10-47T 47
- 8. ELECTRICAL CONNECTIONS 48
- 9. REFRIGERATION DIAGRAMS 49
- 9.1.2 KN 30 R410A 50
- REFRIGERATION DIAGRAMS 51
- 9.1.3 KN 36 R410A 51
- 9.1.4 KN 36T R410A 52
- 9.1.5 KN 45T R410A 53
- 9.2 Cooling Only Models 54
- 10. TUBING CONNECTIONS 55
- ¼” ⅜” ½” ⅝” ¾” 55
- 11. CONTROL SYSTEM 56
- CONTROL SYSTEM 57
- 11.2 Control Function 59
- 11.3 General Functions 60
- 11.3.5 Protections 61
- 11.3.6 Thermistors Operation 61
- 11.3.7 RV Fault 62
- 11.3.8 General Features 62
- 11.4 Cooling Mode 63
- 11.4.3 Sequence Diagrams 64
- (RT - SPT) [ 65
- 11.5 Heating Mode 66
- 50)2( tt ICTandSPTRT 68
- 11.6 Heating, RC or SH Group 69
- 11.7.1 Sequence Diagram 70
- 11.8 Heating, RH Group 71
- 11.10.2 Sequence Diagrams 74
- 11.11 Dry Mode 75
- 11.11.2 DRY, SH or RH group 77
- 11.12 Protection 78
- Time [Hr] 85
- 11.16 System Diagnostics 91
- 12. TROUBLESHOOTING 92
- TROUBLESHOOTING 93
- 13.5 Indoor Unit: KN 36 98
- 13.6 Indoor Unit: KN 45 99
- *Optional 102
- 14. OPTIONAL ACCESSORIES 130
- Service Manual - KN Series 132
- OPTIONAL ACCESSORIES 132
- Revision Y06-02 132
- APPENDIX A 136
- CONTENTS 137
- INSTALLATION 138
- NAMES AND FUNCTIONS 140
- OPERATION ATTENTION 141
- TEMPORARY OPERATIONS 142
- ADJUSTING AIR FLOW DIRECTION 142
- MAINTENANCE 143
- RESTART AFTER A LONG TIME 145
- TROUBLES AND CAUSES 146
- REPARATION 147
- PRECAUTION 149
- INSTALLATION INFORMATION 150
- ATTACHED FITTINGS 151
- INSTALLATION PLACE 152
- INDOOR UNIT INSTALLATION 153
- CAUTIONS 154
- OUTDOOR UNIT INSTALLATION 156
- INSTALL THE CONNECTING PIPE 157
- Flaring the nuts 158
- Use the market brass pipe 158
- Operate the stop valves 160
- CHECK THE LEAKAGE 160
- CONNECT THE DRAIN PIPE 161
- WIRING 163
- 3. ELECTRICAL CONNECTIONS 164
- Figure 36: Three Phase Units 165
- 3.2 Interconnecting cable 165
- Chart 38 167
- TEST OPERATION 168
Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electra OU7-24 RC
(92 paginas)
(14 paginas)
(2 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.085 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales